thoroughly (adv)  FULLY  FULLY DRY THE SURFACE.  Dry surface thoroughly.
 THOSE (pn)  Function word that shows the persons or "things" referred to  WHEN YOU EXAMINE THE PARTS, DISCARD THOSE THAT ARE DAMAGED.  
 thread (v)  PUT, TURN  PUT TAPE ON THE ROLLER.  Thread tape over the roller.
       TURN THE LOCK NUT ON THE FITTING.  Thread lock nut on fitting.
 threaded (adj)  THREAD (TN)  PUT THE END OF THE ROD THAT HAS A THREAD IN THE FITTING.  Put threaded end of rod in the fitting.
 THROUGH (adv)  From one end or side to the other, "by way of"  IF FUMES COME THROUGH THE FLOOR INTO THE CABIN, DO THE EMERGENCY PROCEDURE.  
 THROUGH (pre)  From one end or side to the other, "by way of"  MAKE SURE THAT THE FLUID THAT GOES THROUGH THE TUBE HAS NO BUBBLES.  
throughout (pre)  DURING  MAKE SURE THE DOORS ARE CLOSED DURING THE PRESSURIZATION TEST.  Make sure the doors are closed throughout the pressurization test.
 THRU (pre)  From XXXX to XXXX "inclusive"  DO STEPS 4 THRU 10 AGAIN.  
 THUS (adv)  For that "reason"
 NOTE : For other meanings, USE: FOLLOW (v), BECAUSE (con).  THIS BOILER CONTROLLER IS APPLICABLE TO ALL SYSTEMS.  THUS, IT CAN ALSO CONTROL THERMAL OIL HEATERS.  
 tie (v)  ATTACH  ATTACH THE THREADING CORD TO THE NEW CABLE.  Tie threading cord to new cable.

 
 
 TIGHT (adj)
 (TIGHTER, TIGHTEST)  Not free
 NOTE : For other meanings, USE: SEAL (v), TENSION (TN).  MAKE SURE THAT THE NUTS ARE TIGHT.  
 TIGHTEN (v), TIGHTENS, TIGHTENED, TIGHTENED  To cause to be tight  TIGHTEN THE SCREWS.  
 TIGHTLY (adv)  In a tight "manner"  HOLD THE CYLINDER TIGHTLY.  
 till (con)  UNTIL  MOVE THE LEVER UNTIL IT TOUCHES THE STOP.  Move the lever till it hits the stop.
 TILT (v),
 TILTS, TILTED, TILTED  To move or put something at an angle (TN) between the vertical (TN) and the horizontal (TN)  TO ALIGN THE BOLT, TILT IT TO THE LEFT SIDE.  
 TIME (n)  1. A "duration" that you can measure   THE TIME BETWEEN CLICKS MUST BE 20 SECONDS.  
    2. "Repetition" of an "occurrence"  DO STEP 2 THREE TIMES.  
time (v)  TIME (n)  MEASURE THE TIME NECESSARY FOR THE PRESSURE TO DECREASE.  Time the pressure decay.
 tip (n)  POINT  BEFORE YOU MAKE THE HOLE, MAKE SURE THE POINT OF THE TOOL IS SHARP.  Before you make the hole, make sure the tip of the tool is sharp.